Hayward EasyTemp heat pump pool heaters are a great way to efficiently heat your pool. Heat Pumps offer great efficiency since they do not produce heat but simply transfer heat from one place to another using a reverse refrigeration process.
The Hayward EasyTemp heat pump pool heaters pull heat from the ambient air surrounding the heat pump through a coil then using a reverse refrigeration process transfer the heat from the air into the water inside of a titanium heat exchanger that is highly resistant to the chemicals used in your pool. The water is circulated through the EasyTemp heat pump pool heater by the pool filter pump spreading the heated water through your entire pool with no additional pumps needed.
Hayward has been making pool equipment for over 80 years and they are recognized as an industry leader making high quality reliable pool equipment. The Hayward EasyTemp heat pump pool heaters are made in 65,000, 80,000, 110,000, and 125,000 BTU sizes giving you a full array of heat pump sizes to heat your pool. At the heart of each EasyTemp heat pump is a scroll compressor, which is the present heat pump industry standard. The EasyTemp is controlled by an electronic board that can control the temperature of your pool to within ½ degree F from the temperature you set for maximum comfort. The electronic control board also offers a full range of system analysis and diagnostics including low refrigerant gas, high pressure or low flow, sensor malfunctions and system operation. The Hayward EasyTemp heat pump pool heaters operate on single phase 240-volts AC.
Heat Pump pool heaters offer a different way of heating the pool and do not deliver the higher BTU/hr heating that oil and gas fired pool heaters deliver instead they have a slower lower BTU/hr heating that often requires longer running times to heat the pool but ultimately heat the pool at a much lower cost than the other burner type heaters that expend greater amounts of energy to produce heat rather than simply moving existing heat from one place to another. The Hayward EasyTemp heat pump pool heaters can operate in “Pool Mode” heating up to a maximum of 95 F/35 C and in the “Spa Mode” heating to a maximum of 104 F/40 C.
The Hayward EasyTemp heat pump pool heater is well constructed for years of reliable service with a UV resistant plastic cabinet that is essentially maintenance free, the operation of the heat pump on occasion will generate condensation and the plastic cabinet is well suited to handle the exposure to the moisture. The maintenance on the EasyTemp is limited to keeping the drains on the plastic cabinet clear, the evaporator coil may accumulate dirt and can simply be sprayed with a hose to clean it without damaging the fins. The water quality is important with any pool heater to protect the heat exchanger and strict control of PH, Chlorine Concentration, Total Alkalinity, Total Dissolved Solids, and Calcium Hardness should be maintained in your pool water for maximum life of the pool heater. The winterization of the Hayward EasyTemp is a snap where all you have to do is shut off power to the unit, break the union connections at the inlet and outlet, then either tilt and get all the water out or, blow it out with air, then reconnect the water lines, and cover the unit to keep snow from getting inside.
The Hayward EasyTemp heat pump pool heaters come with 2-Year Parts and Labor Warranty on the entire unit, a 5-Year Parts Warranty on the compressor, and a 10-Year Parts Warranty on the heat exchanger. Labor outside of Florida is limited to 1-Year.
