The EdenPure Heater is used each year by many people to space heat used areas of their home helping them to keep the heat setting low throughout the home. This helps many people to save money on their heating bills.
When getting ready for the heating season you should inspect the EdenPure Heater to make sure that it is ready for use. Make sure that the EdenPure Heater hasn’t been damaged while being stored in the off-season. Inspect the power cord and plug making sure that if hasn’t been damaged and is ready for use. Check the cabinet and control panel for and signs of damage. Make sure the remote control has fresh batteries installed and ready for use. Finally plug in the heater and test its operation and all the control settings for proper operation.
It is very important that you perform these checks early enough that you have time for needed repairs to be done before you need the heater to heat your home. If you are handy and want to make repairs on the EdenPure Heater yourself you can simply buy the parts you need through the EdenPure Heater Store. They sell all the commonly needed parts such as sets of bulbs, fans, and sensors.
If you are not the repair it yourself type you can always send it in to the EdenPure Heater Store for service. The EdenPure Heater Repair Facility is located at Affordable Heat, LLC. Service Center 1139 Treat St. Adrian, MI. 49221 just north of Rt. 223. They have several different repair options available for you to choose from.
- The lowest cost repair has a charge of $64.95 for labor, shipping & handling, and upon receiving the unit the EdenPure Store will call you with the parts prices your unit needs for authorization before proceeding. After repairs are completed the EdenPure Heater will be returned to you with a 30-Day Warranty.
- The next level of service goes for $119.95, which includes labor, shipping & handling, all expired parts, and a 90-Day Warranty.
- The highest level of service is the “Complete Revamp Option” goes for $199.95 and they will replace all the parts including a heat sensor, complete set of bulbs, thermostat sensor, fan, fan sensor, control board, filter, and transformer. This will ensure that your EdenPure Heater is “Like New.”
- Of course if your EdenPure Heater is under Warranty you should follow the instructions for your Warranty repairs.
Once your EdenPure Heater has been checked out for proper operation and safe condition you are ready to set up and use the heater. Even though the outside of the EdenPure Heater is cool and won’t burn you the heater should be set up where the air is free to circulate for maximum effectiveness. The EdenPure Heater should also be set up out of the normal traffic patterns in the room to eliminate possible tripping hazards. Make sure that the power cord is routed where the cord will not present a tripping hazard and the cord is not likely to be damaged. Never route the cord through doorways, or under rugs. If you use an extension cord make sure the extension cord has a sufficient gauge for the load of the EdenPure Heater to prevent the cord from overheating and causing a fire. Whenever space heaters are used people should make sure they are used in a safe manner to avoid the possibility of serious injury and even death that could result from unsafe use.